For the expedition model first, we must ensure that its production speed, we will talk about the production of 24-hour expeditions of FPC. The shortness of production means that it is necessary to ensure a number of success, because the time is not allowed to carry out the production equipment, technology, selection, materials, producers, etc. of a company, high requirements.  
1. Quickly optimize design graphics, when you get a design drawing, you must first make sure it is reasonable. Second, you should optimize the design graph to ensure that the product removes excess line without affecting performance, reducing the wiring area.  
2. Use the appropriate substrate, which is one of the important factors when producing an increase in the bov. The selection of the circuit board is a variety of diverse, and the production of the production of the plus roller board will result in a variety of elements outside of the expected expectations when producing. Our Kaber Technology generally selects high molecular polymerization resin production, which is relatively stable, which is high temperature, not easily deformed, and is good bent, which is well-deformed.  
Rework and heavy work.  
4. Check that the wire board is obtained after the finished product, check whether the product is welded and expected to do not match, such as: short-term, miscible, component reverse and air welding and welding.  
5. Product testing, product testing data analysis can be used as a basis for designing product parameters correction. The electrical test of the finished circuit board is the most fundamental, and the circuit board lines are definitely not possible. Generally, these methods are used for circuit board electrical testing: special type, usually used in mass production. There are also high-end flying needles and composite trunks that can be electrically tested and the conductivity of the product is tested.  
6. The requirements of the producer, the time is cost. Ensure that rapid production is rich in production personnel, because there are many procedures for the circuit boards that require manual operations, employees with strong production capacity are a real capital of a rapid capacity of the line board factory.